Specifications

UHP-1000 SATELLITE ROUTER
INSTALLATION AND OPERATION MANUAL, V. 2.5
(SW VERSION 2.5.X)
© ROMANTIS 2012 39 www.romantis.com
Altogether, the Table can contain up to 1,000 records. Routing speed is practically independent of the number of
records.
Figure 16 Routing layout with examples of commands
Records to the route Table come from two sources – local settings and the routing table received from the Hub.
Routes from Hub are always entered in the routing table. Local configuration routes are entered only if it is
permitted from Hub or if routers routing remote control system is switched off on Hub. On Hub, you can allow or
prohibit, for each individual router, reception of various routing records from the local configuration. For example,
you can allow local administrator of the router add static routes but prohibit changing IP-addresses and SVLAN.
All records are provided with counters of packets that have been routed as per these records. This will make
diagnostics easier.
UHP-1000 router has no limitations on overlapping the addresses, incompliance of masks, etc. This makes it
possible to obtain more capabilities from routers but these capabilities should be used with care.
2.10.3 Router control commands
---------- IP parameters
ip address IP_ADDR IP_MASK [1-1020] - Add IP address to interface [VLAN]
Adding IP-address to the Ethernet interface. The address and mask are separated with a blank.
Multiple addresses can be defined. If non-zero VLAN is specified then the address is added to the
route Table of this VLAN.
ip route IP_ADDR IP_MASK IP_ADDR [1-1020] - Add static route [VLAN]
Adding static route.
Availability of the route destination address is not checked.
ip map IP_ADDR IP_MASK ml|mm|mh|md 0-1020 [0-500] [1-1020] - Route network to
TX SVLAN [TrSh] [VLAN]
Route for transmitting IP-network via satellite. Parameters:
ml|mm|mh|md - Transmit priority (High, Medium, Low, DSCP).
0-1020 - SVLAN number (0 – transmit without SVLAN encapsulation).
0-500 - Traffic Shaper channel number to pass the traffic. Optional parameter. If it’s not
specified, the traffic will go via channel 0 the configuration of which should be
checked at least once to avoid surprises.
1-1020 - VLAN number the record is referred to.
The depth of queues could be defined by command “queue” described in the paragraph 2.7
svlan receive demod|tdma 0-1020 [1-1020] - Add RX SVLAN [VLAN]
Add SVLAN reception from one of demodulators. When VLAN is specified the traffic will go to its route
Table instead of the basic one.
Modulator
SCPC demodulator
TDMA demodulator
TS
IP Router
Local IP
stack
LAN
svlan receive de SVLAN VLAN
svlan receive td SVLAN VLAN
ip map ADDR MASK PRIORITY SVLAN TS VLAN
ip address ADDR MASK VLAN
ip route ADDR MASK VLAN
H
M
L
SVLAN encapsulation
SVLAN decapsulation