Specifications

UHP-1000 SATELLITE ROUTER
INSTALLATION AND OPERATION MANUAL, V. 2.5
(SW VERSION 2.5.X)
© ROMANTIS 2012 31 www.romantis.com
REMOTE#de be qp
QPSK BERT Q-quit
+00:00:03 С/N=7.2 (7.0<>7.2) BER_1s=8.0E-3 BER=8.0E-3 CRCs=0
+HH:MM:SS - Duration of the test.
С/N - Current carrier-to-noise ratio in decibel.
(...<>...) - Minimum and maximum signal-to-noise ratios during the test.
BER_1sec - Bit error rate at this instant.
BER - Average level during the test.
Demodulator settings and statistics of operation can be displayed using “show interface demodulator” command:
REMOTE#sh in de
Demodulator interface is UP
Last U->D: never U>D transitions:0
Last D->U: +00:00:03 Counters reset: never
------------------------- Outdoor Unit --------------------------
| LNB-pwr: ON T10M: ON Offset: 0 KHz Search BW: 2000 KHz |
LNB power - LNB power supply on/off.
T10M - 10MHz Reference signal on TDMA Rx input
Offset - LNB frequency offset saved by the demod compensate command
Search BW - Carrier search bandwidth.
Profile settings
------------------------- Link profiles -------------------------
| Pr| State | Frq.KHz | Polar.| SR.KSps | FEC | SpInv | Mode |
| A | RECEIVE | 1497220 | H 18V | 2105 | AUTO | AUTO | S1 |
| B |DISABLED | 1351000 | H 18V | 300 | AUTO | AUTO | S1 |
Pr - Profile.
State - Current state:
RECEIVE - Carrier is being received.
SEARCH - Carrier search under way.
STANDBY - Profile is on but at the moment another profile is working.
DISABLED - Profile is off.
Frq.KHz - Central frequency.
Polar. - LNB polarization and supply voltage (is permitted).
SR.KSps - Symbol rate.
FEC - Noiseless decoder mode.
Spinv - Spectrum inversion mode.
Mode - DVB-S1 or DVB-S2 demodulator mode.
Receive signal statistics in DVB-S1 mode
----------------------- Demodulator state -----------------------
| InLvl | SpI | FEC | RS | SRoff | RX_BER | C/N | RX-offset |
| -58.7 | OFF | 3/4 | LOCK | 0 | 6.0E-3 | 7.2 | -9 KHz |
Current state of the demodulator receiver:
InLvl -Common level of signal on the input. “NOSIG” for level <-85dBm
SpInv - Spectrum inversion current mode.
FEC - Viterbi decoder mode.
RS - Carrier capture. LOCK means that the carries is detected.
SR_off - Correction to the symbol rate (smb/sec). Not valid during search.
RX_BER - BER in receive mode. Not valid during search.
C/N - Signal-to-noise ratio in dB. Not valid during search.
RX-offset - Carrier frequency offset from the assigned value including Offset parameter. Large offsets
(up to 1000 KHz) do not affect reception quality but slow down search operation.
Receive signal statistics in DVB-S2 mode.