Specifications

UHP-1000 SATELLITE ROUTER
INSTALLATION AND OPERATION MANUAL, V. 2.5
(SW VERSION 2.5.X)
© ROMANTIS 2012 25 www.romantis.com
You can print the list of current errors using command:
ERROR!!! UHP# show errors
Hardware errors inform you about hardware problems with the router:
Message
Comment
RAM fail
Errors with router memory
LAN fail
Errors with Ethernet interface
FPGA fail
Errors in the programmable logic of router
Demodulator fail
Errors with SCPC Rx interface
Burst demod. fail
Errors with TDMA Rx interface
Software or Mode of Operation errors indicate any mismatch between hardware, software and activated feature
licenses.
Message
Comment
Unit mode not supported by SW
This mode is not supported by active software
SW option missing
Activated mode required special SW feature license
Configuration error messages focus user’s attention on the most important points in the router configuration, that
may lead to instability of operation.
Message
Comment
DVB-S2 RX not supported
DVB-S2 RX not supported
FEC cannot be used
FEC cannot be used
Long frames cannot be used
Long frames cannot be used
DVB-S2 16APSK SR>28000
The maximum symbol rate limit exceeded for DVB-S2 16APSK
Burst duration too small
Too little length of TDMA time slots (less than 0.3 msec.)
Frame duration invalid
TDMA frame duration is outside the operating range: from 0.05 to 2 sec.
Idle / down counters too low
Too low values for the status of IDLE/DOWN
Too many guaranteed slots
Guaranteed time slots allocated more than there are time slots in a
backward channel.
2.3 Interface management
Router interfaces feature the following designations in the commands set:
Ethernet - Ethernet LAN (LAN)
Demodulator - High speed demodulator (SCPC Rx)
TDMA - Packet demodulator (TDMA Rx)
Modulator - Modulator (Tx OUT)
Each interface is provided with a page showing parameter settings and operation statistics. The page is called using
“show interface ...” command with the interface name. Each page starts with the following header:
UHP#sh in et
Ethernet interface is UP
Last U->D: never U->D transitions:0
Last D->U: +00:00:04 Counters reset: 17.Oct 09:00:18
...
The first string shows the current state of the interface: