Specifications
UHP-1000 SATELLITE ROUTER
INSTALLATION AND OPERATION MANUAL, V. 2.5
(SW VERSION 2.5.X)
© ROMANTIS 2012 24 www.romantis.com
useful to restore operation in emergency cases. Printout of command is not transmitted back as the SNMP
response? So command execution is “blind”.
2.2.9 Command interface and command syntax
When opening a command session (Telnet of USB) the router can, depending on the configuration, request a
password. If password is not set the commands can be entered immediately.
The system invitation starts with the router name (it is set using the relative command). Then enter «#» symbol in
the administrator mode or «>» symbol in the user mode (user cannot change configuration).
Router commands include key words and parameters. All key words can be reduced to two letters. Letter case is
unimportant. Wrong entered symbols can be edited by returning to them using Backspace key. “Left” and “right"
arrows cannot be used for editing. “Up” arrow is used to recall commands used earlier.
Commands list can be printed using “help”.
UHP# he
---------- Interface control
interface ethernet|serial|demod|modulator disable|enable - IF Control
clear interface ethernet|serial|demod|mod - Reinitialize interface
---------- Ethernet interface parameters
ethernet mode ehalf|efull|fhalf|ffull|auto - Speed and duplex selection
arp timeout 30-3600 - ARP table purge interval
---------- Demodulator common parameters
demodulator lnb frequency 0-14000000 - LNB LO frequency (KHz)
demodulator lnb power off|on - LNB power control
demodulator search 0-200000 - Carrier search bandwidth (+/-KHz)
demodulator reference off|on - TDMA RX connector 10 MHz output
---------- Demodulator profile parameters
demodulator profile a|b disable|enable - Enable/disable profile
demodulator polarization a|b vertical|horizontal - Polarization
demodulator frequency a|b 950000-21500000 - Central frequency (KHz)
Command syntax meaning:
[ ] - optional parameter
x|y - selection of one of the key words, e.g. “on” or “off”
x-y - numerical value in the range from x to y inclusive
STRING - symbols string
IP_ADDR - IP address, e.g. 192.168.0.1
IP_MASK - IP mask in classical or CIDR form (255.255.255.0 /24 /32)
ADDRESS AND MASK MUST BE SEPARATED BY BLANK SPACE – THESE ARE DIFFERENT PARAMETERS.
ML, MM, MH, MD - abbreviations for the name of the modulator transmission priority queues (Low,
Medium, High, DSCP)
2.2.10 Error alerts.
In the router software, there is an information block, which indicates any configuration errors. The following
console prompt appears if the router has any configuration errors:
ERROR!!! UHP#
There are three types of messages:
Hardware errors
Errors associated with the wrong choice of software or router mode
Configuration errors.