Specifications

UHP-1000 SATELLITE ROUTER

INSTALLATION AND OPERATION MANUAL, V. 2.5

(SW VERSION 2.5.X)

In case the satellite routers have been preconfigured at the factory on customer’s request such routers may have

different default IP address. In such case the respective IP addresses will be listed in the passport of the router. If

it’s impossible connecting the router with any of specified addressed please reset the router to factory settings.

2.2.6 HTTP interface

HTTP (WWW) interface is intended for the initial configuration of the router to operate in a TDM/TDMA terminal

mode (main mode of operation), as well as for monitoring key parameters in the process of satellite pointing and

its further exploitation. Configuration of the router to work in other modes of operations is described hereafter

and in respective Addendums to this Manual

Figure 13 Router statistics page

2.2.7 Local access via USB

When router is connected to a computer via a USB cable the computer creates a serial COM port. The port number

can be found in the Device Manager. To access the port use can be made of either the OS-integrated terminal

(Hyperterminal) or third-party terminal programs.

With the fist connection of UHP-1000 Router to PC the system will request the device driver. UHP.INF driver is

available on CD with documentation or can be downloaded from our web site. In response to the request for

driver you should refuse from search in Internet and select setting from the specified place where UHP.INF is

saved.

The system will request confirmation for using a non-certified driver. Ignore any system warnings and proceed

with installation. When finished, please check whether a COM port appeared in the Device Manager. If it is

appeared you can start working with the router.

When working with the port from the terminal program the data rate and control parameters can be set to any

value since they are ignored.

WITH USB OC PROTOCOL STACK – THERE IS A PECULIARITY WHICH LEADS TO “HANGING” OF THE USB-PORT IF IT

CARRIED AN ACTIVE SESSION AND THE CONNECTED DEVICE (ROUTER) AT THIS MOMENT WAS REBOOTED. IN THIS CASE

YOU HAVE TO LOG OUT FROM THE TERMINAL PROGRAM AND LOG IN AGAIN. YOU CAN AVOID THIS BY CUTTING OFF THE

SESSION BY “HANG-UP” COMMAND AND ONLY THEN RESTART THE ROUTER USING RESET BUTTON OR VIA POWER

SUPPLY CIRCUIT.

2.2.8 Remote Telnet access

Remote access to the configuration can be performed using Telnet protocol. The connection can be provided to

any of IP addresses that are set on the router. UHP-1000 supports simultaneously only one Telnet session. In order

the hang session does not block access to the device forever in case on non-activity (pressing ENTER key), the

router auto-terminates the session after a certain time of inactivity. The time can be set in the configuration, and

by default it is 10 minutes.

There is one more (emergency) method to issue commands to the router remotely. One of the SNMP variables

allows, after a text string is transmitted to the router using SNMP protocol, execution of this string as a command.

The advantage of this method is that a reverse channel for transmission of commands is not a must – this can be