Specifications

ManualsBrandsRomantis Satellite Communications ManualsComputer equipmentUHP-1000

UHP-1000 SATELLITE ROUTER

INSTALLATION AND OPERATION MANUAL, V. 2.5

(SW VERSION 2.5.X)

Figure 11 Example of router’s connection in SCPC or TDM/TDMA terminal modes

Typically, the router UHP-1000 is connected to individual RF frequency equipment (ODU). In such

configuration IF output of the modulator is connected to the power amplifier BUC, and the input of

high-speed demodulator to LNB (Figure 11). The router will supply the BUC with 24V power and 10MHz

reference signal. Also, the router may provide LNB with 18V DC power. The user’s equipment should be

connected to the router via Ethernet switch or hub, if you plan to connect only one device, it can be

connected directly with Ethernet cross-over cable.

Figure 12 Example of router's connection in TDM/TDMA MESH mode

In the TDM/TDMA MESH mode the inputs of high-speed and burst demodulators should be connected to LNB via

IF splitter (Figure 12). Such splitter has to ensure by-pass of DC for powering of the LNB and 10 MHz reference

signal (required for PLL LNB normally used with Mesh terminals or Hubless Stations).

2.2.4 Powering on

In a few seconds after powering the router it is ready for use. Readiness of the router will be confirmed by

"STATUS" LED indicator (blinking with a period of 1 second), as well as by single flashes of "ERROR" indicator,

meaning a lack of reception of the receiving carrier.

With factory setting the router is configured as TDM/TDMA terminal. The router requires change of mode of

operation (if necessary) and/or configuration of respective network parameters before login into satellite

networks.

The easiest way to configure the router is using its HTTP access via its LAN port.

2.2.5 Local access to router via HTTP interface

HTTP (WWW) interface allows configuration key parameters and monitoring its actual status of the router. Local

Web page of the router can be accessed from any Internet browser.

By default, UHP-1000 router is configured with IP-address 192.168.222.222 with mask 255.255.255.248 (/29).

Respectively, the computer should be configured with an address, e.g. 192.168.222.217 with the same mask.

LNB

UHP-1000

TDMA Rx

MCPC Rx

LAN

ETHERNET SWITCH

BUC

(24V, 10MHz)

(18V)

User’s equipment