Specifications

UHP-1000 SATELLITE ROUTER

INSTALLATION AND OPERATION MANUAL, V. 2.5

(SW VERSION 2.5.X)

1.2.10 “STATUS” Indicator

“STATUS” green indicator indicates the router operation mode. This indicator is always flashing. If it does not flash

it means that the router is not functioning (please check power supply). Slow flashing (once every second) means

router normal operation. Faster flashing (3 times every second) means that a Telnet remote control session is

established (in this case USB console does not operate until session is over).

Fast (6 times every second), simultaneous flashing of “ERROR” and “STATUS” indicators means that the router is

functioning with the factory default configuration. Access to the router in this mode is possible either via USB of

via IP-address 192.168.222.222 (mask 255.255.255.248 or /29).

1.2.11 “LOCK” Indicator

“LOCK” green indicator indicates whether the router receives a channel from the central station. If there are CRC

errors during reception of information from the channel (e.g. with weak signal from the antenna), the indicator

extinguishes for a fraction of a second at every error. If there are too many errors the indicator may not glow at all

in spite of the fact that the router receives the channel (in this case please check the router demodulator

statistics).

1.2.12 “TDMA” Indicator

“TDMA” yellow indicator flashes every time a data placket is received via TDMA RX interface.

1.2.13 “SCPC” Indicator

“SCPC” yellow indicator flashes every time a data placket is received via SCPC RX interface.

1.2.14 “TX” Indicator

“TX” yellow indicator flashes every time a data placket is transmitted in the MCPC mode, and also a blank packet –

in the TDMA mode (if no data is available for transmission).