Specifications

UHP-1000 SATELLITE ROUTER

INSTALLATION AND OPERATION MANUAL, V. 2.5

(SW VERSION 2.5.X)

1.2 Description and principles of operation

1.2.1 Overview

Each module of -1000 satellite router has its own interface to external devices. All the interfaces are

located on the rear panel of the device. The indicators are located on the front panel. LAN Indicators are

integrated into the LAN connector on the back of the router.

Figure 8 UHP-1000 series modem – rear view

1.2.2 Power connector (DC IN)

UHP-1000 router is powered with 24 VDC. AC Power supply adaptor is supplied with the set. The router can be

powered from a DC power source (batteries, DC-DC converter), but the specific power supply mode should be

agreed upon with the Manufacturer. Power supply connector features dimensions 5.5 / 2.1 mm (outer and inner

diameters). Positive terminal of the source is on the central contact.

1.2.3 LAN interface connector

LAN connector is purposed for connecting to Ethernet switch using a straight cable. Bit rate 10 or 100 and duplex

mode are software selectable. Indicators built into the connector mean the following: left one (green) –

connection (Link) and data transmission (Activity), the right one –yellow) – activation of half-duplex mode.

1.2.4 USB CONSOLE

The console port provides local control of the device.

1.2.5 RESET button

Router reset is provided using this button. Also, using special combination of pressings this button allows router

reset to factory settings.