User`s guide

16
Replacing the Battery
This organizer uses one CR2025, 3-volt lithium battery.
Before you follow these steps you should have a small
Phillips screwdriver and a new battery in hand.
Warning! When no battery is installed, this organizer will
save your information for only about 30 seconds. So
quickly install a new battery when you remove the old one.
1. Turn off the organizer and turn it over.
2. With the Phillips screwdriver, remove the two
screws at the top of the battery cover and then re-
move the lid itself.
Do not remove the screws at the sides of the organizer.
3. Remove the old battery and quickly replace it with
the new battery, with its plus (+) sign facing you.
4. Replace the battery cover.
Warning! If RESET? appears when you next turn
on the organizer, do not press ENTER unless you
want to reset the organizer and erase all your infor-
mation (see below).
To Reset the Organizer
Warning! Resetting the organizer permanently erases
all the information entered in it. Perform a reset only
when you want to erase and lose all your information.
1. If needed, turn the organizer on.
2. Using the pointed end of a paper clip, press the re-
cessed RESET button on the back of the organizer.
RESET? should appear on the screen.
3. Press ENTER to reset the organizer or any other
key to cancel the reset.