Installation manual

Page 26 RS-500/600 Door Part No 4801-5166 Rev 01-2015
16 Removal of existing Panel/Curtain Material
Warning!
The Curtain Is Released When Brake Lever Is Disengaged.
Do Not Disengage Brake Until Door Opening Is Clear!
1. Locate the door controller and turn off the power switch on the left side of the controller.
2. Locate the brake on the motor. It resembles a paint bucket handle that has been pushed upon a clip. Pull
the brake release handle down towards the floor. This will allow the panel to go to the floor.
NOTE: You may have to assist by rolling the panel downward.
3. Remove the Head Unit Cover and lower to the floor.
4. Locate the 3 fabric sheets that make up the entire door curtain. See Diagram 15B, Page 25. The center
panel has a hook & loop strip across the top. The center panel does not have magnets or hook & loop strips
on the sides. The inside and outside panels have hook & loop strips at the top, and magnets or hook & loop
strips along the sides of the panels. The outside panel may be identified as the longer of the two panels.
5. Mark the end of each sheet and along the edge of each sheet with a marker. This will prove vital to ensure
you install the new panel sheets at the proper locations to alleviate major curtain adjustment.
6. Remove the 3 screws from each sheet (front, center, and back). See Diagram 15B, Page 25. Detach the
hook & loop area of each sheet left to right, starting with front, then center, and then back sheets. Let the
panel/curtain fall to the floor.
NOTE: If the door is equipped with an egress assembly you will see the yellow egress strap
attached to a triangle piece of material with a quick-link connector. If it does not
have this strap, read the notes below and proceed to next step 8.
7. Un-screw the quick-link connector and allow the panel to hit the floor.
NOTE: Observe how the tension pipes are installed before removal. They MUST be re-
installed first, with one pipe in the front/outer pocket (closest to outside of the
cooler) and the other pipe in the back/inside pocket. Locate the back pipe behind
the triangle piece that is attached to the yellow strap. The front/outer pipe will
always hang lower than the back/inside pipe.
NOTE: Failure to install properly could result in door sticking up.
8. Slide the 2 tension pipes out of their respective pockets. Remove the panel/curtain away from the door.
You are now ready to install the new panel/curtain.
17 Installation of Replacement Curtain
1. Place the new panel in front of the door opening and make sure the part number label is on the left side.
NOTE: If door is equipped with egress system yellow strap ensure that the strap is
positioned to the front side of the back/inside panel to allow connection to the
triangle piece of material with the quick-link connector.
2. Take the back/inside curtain (Diagram 17A, Detail 1 and Detail 2) and attach the material to the backplate
placing material on the marks that were created during removal of old panel.
3. After the inside curtain has been attached, attach the egress strap (if equipped) to the triangle piece of
material with the quick link connector.
4. Take the outside curtain (Diagram 17A, Detail 1 and Detail 2) and attach to the top bar.
!