Installation manual

Page 52 RS-500/600 Series Doors Part No 4801-5154 Rev 01-2015
35 Removing and Replacing Floating Magnets or Velcro
1. Open the door to its upper limit. It will be necessary to raise the panel as high as it will go into the head unit.
Refer to manual operation of associated operator as shown previously in this manual. This will make it easier
for you to remove and re-install the “Floating Magnets or Velcro and PIM Plate Assemblies” from the left and
right side tracks (Diagram 35A).
Diagram 35A
Warning!
Ensure power is turned “OFF” to prevent door movement while removing
PIM Plate Assembly and Floating!
Ensure panel is
raised into the head
unit.
!