Installation manual

Page 44 RS-500/600 Series Doors Part No 4801-5154 Rev 01-2015
22.3 Switch Operation of Door with Manaras Operator
To Operate Door:
1. Depress the “Close” button on the Open/Close/Stop switch. Door curtain will unroll to 'closed'
position.
2. Depress the “Open” button on the Open/Close/Stop switch. Door curtain will open to 'Open' position.
3. Depress button to open or close door as desired.
4. Open and close the door a few times to test door operation and remove any wrinkles in the door
curtain.
5. If you detect any problems, STOP. Disconnect electrical power. Contact your distributor for
assistance.
28 Manual Operation Manaras Operator
The RS-500/600 Door can be operated manually in the event of a power outage or if there is a motor malfunction.
To operate the door manually, perform the following instructions.
Warning!
Do not attempt to manually operate the door while the operator is running. Do not attempt to
manually force a malfunctioning door to open or close. The chain is an emergency device
and is not designed to operate a door with serious mechanical problems.
Chain Adjusting Nut
1. Pull on the hand chain in the down direction. The first foot
pulled will engage the chain hoist mechanism and disable the
electrical circuit.
2. Continue to pull the chain in the desired direction. Repeat
actions 1 and 2 in the opposite direction if the door does not
run in the desired direction.
3. To return to electrical operation, pull slightly on the chain in
the opposite direction.
5. Adjustment of the door is required if no door movement
occurs after two feet of pulled chain. To adjust, turn the
adjusting nut clockwise (See Diagram 28A) by ¼ turn until
the hoist engages after pulling one foot of chain.
NOTE: If the nut is too tight, the manual torque
on the chain will be too heavy.
Warning!
NEVER RELEASE CHAIN! If Chain Is Released, Door Will Drop With Rapid Motion.
Injury May Occur If Chain Is Released!
Do not remove the cable tie securing the chain to the chain guide until after the
chain bracket is completely installed and the chain is secure. Remove and discard
the cable tie securing the chain to the chain guide prior to manual operation.
!
!