® 24V Wave Catcher NOTE: The unit must be traveling at least 3 mph (5 km/h) before motor will engage. Kick to start until you reach at least 3 mph (5 km/h) then press the push button throttle on handlebars to engage the motor. Owner’s Manual and Assembly Instructions Model #: W301 Read and understand the entire manual before assembly and operation. The scooter must be assembled by an adult who has read and understands the instructions. Made in China. Styles and colors may vary. Do not return to store.
Introduction Thank you for purchasing this Rollplay scooter! We hope the rider enjoys it for miles to come. Please read this instruction guide carefully before assembling and operating the scooter. Please contact Rollplay Customer Service with any questions. Keep your sales receipt or register your product at www.rollplay.com. Have your model number and serial number ready before calling. Please have proof of purchase. Hours: 9 AM - 5 PM (CST), Monday - Friday Email: customerservice@rollplay.
IMPORTANT! YOU MUST CHARGE THE BATTERY FOR 12 HOURS BEFORE FIRST USE! Charge the battery after each use. Charge the battery at least once a month, even if the scooter is not in use. It is recommended to charge the battery at least once every 6 months, even when the scooter is not in use. Failure to recharge the battery periodically may result in a battery that will not accept a charge. BEFORE RETURNING YOUR PRODUCT TO THE STORE, CONTACT ROLLPLAY WITH QUESTIONS.
Table of Contents Safety ......................................................... 5 Parts .......................................................... 7 Charging Instructions ................................. 8 Unfolding Instructions ................................ 9 Assemble the Handlebar ...........................10 Assemble the Brake ..................................11 Adjust the Handlebar ................................12 Folding Instructions ...................................
Safety WARNING: SAFETY RIDING RULES • The user must follow all safety rules and guidelines, or serious injury or death may occur to the user. • Always use common sense and safe practices when using the scooter. The user must be at least 8 years old and weigh no more than 65kg (143 lbs). • Do not overload the scooter. Do not remove the weight restriction decals. • Do not operate near loose dirt, mud, sand or fine gravel. • Do not operate near flammable vapors (gasoline, paint thinner, acetone, etc.).
Safety (Continued) elements may damage the enclosed materials. • Store indoors when not in use. Store in a dry environment. • The scooter must only be used with the recommended charger which conforms to UL1310 standard. • Do not charge at or below 32°F (0°F). Do not store in freezing or below freezing temperatures. Should be stored in temperatures below 86°F (30° C). • The included lithium-ion battery must be recycled or disposed of in an environmentally safe manner.
Parts 14 1 7 11 9 12 10 13 7 2 8 6 5 4 3 1. Handlebar 2. Frame 3. Front Wheel 4. Rear Wheels 5. Deck 6. Battery Compartment 7. Battery (located in battery compartment) 8. Control Board 9. Manual 10. Charger 11. Wrench 12. Internal Hex Screws (x2) 13. Screws (x2) 14. Blister Pack NOTE: Estimated assembly time is about 10 minutes. Allow 12 hours for initial battery charge.
Charging Instructions YOU MUST CHARGE THE BATTERY FOR 12 HOURS BEFORE THE FIRST USE! ONLY AN ADULT SHOULD HANDLE THE BATTERY AND CHARGER. To Reconnect the Battery: 1. Ensure the scooter is stopped and turned off. 2. Unlock and remove the battery compartment cover (located underneath the deck). 3. Locate the yellow battery connector (A) that attaches directly to the battery. 4. Connect the yellow battery connector (A) to the yellow battery charger connector (B). 5. Replace the battery compartment cover.
Unfolding Instructions 9 WARNING: Keep fingers clear of the pivoting mechanism when folding or unfolding the scooter. To Unfold: 1. Raise the front bar. 2. On a flat surface, lay the scooter down on its side (refer to the position in the figure above), hold the front bar with one hand and the front end of the deck with the other hand. Make sure the up and down arrows on the side are aligned. Push the deck up toward the front bar to connect the two parts until it clicks into place.
Assemble the Handlebar Handlebar 1 Handlebar Shaft 2 1. Locate the internal hex screws (12) and wrench (11) in the blister pack. 2. Locate the wire on the top end of the handlebar shaft (2), connect to the connectors inside the handlebar (1) and gently slide the wires into the handlebar. 3. Insert the handlebar into place on the handlebar shaft. 4. Insert the screws into the holes on the handlebar. 5. Use the wrench to tighten the screws. NOTE: Before each use, check the condition of the handlebar.
Assemble the Brake 11 Brake Pedal Brake Connector 1. Align the two holes on the red brake pedal over the holes on the brake connector. The metal bracket should tuck into the plastic piece. 2. Insert the screws (13) into the holes on the brake connector. 3. Use a screwdriver to tighten the screws.
Adjust the Handlebar Handlebar Lock Pin 1. Unlock the handlebar lock, push the pin into the handlebar. 2. Push down or pull up the handlebar to the next position until it clicks into place. 3. Lock the handlebar lock.
Folding Instructions 13 WARNING: Keep fingers clear of the pivoting mechanism when folding or unfolding the scooter. 1 2 To Fold: 1. On a flat surface, lay the scooter down on its side (refer to the figure above). Hold the front bar with one hand and push in the red button with your thumb while holding the front end of the deck with the other hand. Then slide the front bar away from the deck to unlock the folding system. 2. Carefully collapse the front bar down to fold.
Operating Instructions Throttle Button ON/OFF Button Throttle Button Speed Button 1. Make sure you are in a safe, outdoor environment. 2. Press the ON/OFF Button underneath the deck to turn on the scooter. The red light on the ON/OFF Button will light up to indicate that the power is on. 3. Use both hands to hold the handlebar and carefully step onto the scooter. 4. Kick to start. Once in motion, press one of the thumb throttle buttons to activate the motor.
Rear Wheel Bracket Adjustment 15 Tighten Loosen Riders can adjust the tightness of the skateboard truck to their preference. The tightness of the truck determines how easy the scooter turns and how stable the ride feels. If the scooter feels unstable for the rider, it is recommended to check the rear wheels bracket. It can be adjusted by tightening the nut to increase stability. If the scooter feels too rigid and difficult to turn, slightly loosening the nut will improve the scooter reactivity.
Pre-ride Checklist Frame, Fork and Handlebar Always check that the handlebar is securely upright and is secured at the correct height prior to use. Check for cracks or broken connections. Always inspect your scooter prior to riding. Brake Check the brake for proper function. When you step on the foot brake, the brake should provide resistance. When you apply the brake with the throttle on/engaged, the brake should automatically cut power to the motor.
Maintenance 17 Important Battery and Charger Information • • • • • • • • • • • • Only an adult who has read and understands the safety warnings may handle and operate the battery and battery charger. Keep away from children. Charge the battery for 12 hours before using the scooter for the first time. Charge the battery immediately after each use. Charge for at least 6 hours, but no more than 12 hours. Charge the battery at least once a month, even if the scooter is not used or stored.
• • • • • • General Care Regularly inspect all scooter parts to ensure they are in good working condition. Regularly inspect the charger, cord, plug, and other related parts for damage. Remove any damaged parts and immediately contact Customer Service for replacement parts. See Service and Repairs on Page 21 for more information. DO NOT operate the scooter if there are any damaged parts. Carefully clean the scooter with a damp cloth and mild soap. Do not get water in or near any electrical parts.
Troubleshooting Guide 19 Completely read through the manual and troubleshooting guide before contacting Customer Service.
Repair And Maintenance Cleaning Your Scooter Wipe with a damp cloth to remove dirt and dust. Do not use industrial cleaners or solvents as they may damage the surfaces. Do not use alcohol, alcohol-based or ammonia-based cleaners as they may damage or dissolve the plastic components or soften the decals or decal adhesive. Battery Care and Disposal Do not store in freezing or below freezing temperatures.
FCC Information 21 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Service and Repairs Before returning to the store, contact Rollplay with questions. If your product requires service, repairs or replacement parts, please visit us online at www.rollplay.com Or contact us at: Phone: 1-888-982-9309 Email: customerservice@rollplay.com Web: www.rollplay.com Hours: 9 AM - 5 PM (CST), Monday - Friday For a list of available replacement parts, please visit www.rollplay.com.
Warranty 23 Rollplay 24-Volt Limited Warranty • This one-year limited warranty covers the scooter against defects in materials and workmanship to the original purchaser. Proof of purchase receipt from a Rollplay certified reseller is required. This one-year warranty does not include the 24V Battery.
Product Registration Fill out the form below and mail it to: Rollplay Products 1131 W. Blackhawk St. Second Floor Chicago, IL 60642 com. We will use the information provided only for your warranty. We will not sell, rent or share your personal information. Product Registration First Name: Last Name: Title: Address: City: State: Email: Zip Code: Phone: Date of Purchase: The following product information is on the cover of the owner’s manual.
