Use and Care Manual

14
RolliBot RolliCool 310 Portable AC with Heater User Manual
Section 5. How to Use the RolliCool
The 310 features a number of ways to keep comfortable. Most features can be used by pressing
the buttons on the unit’s control panel, the remote, or via the app.
• Inmostcaseswheretheremotecanbeused,theappcanalsobeusedasasubstitute.
• TokeeptheCOOL310fromllingupwithwatertooquicklywhencertainmodesareused,itmaybebesttoattachthe
 drainagehose.It’srecommendedtoattachthehosetotheupperopeningwhenusingcoolordehumidifymodesandto
 attachittothetheloweropeningwhenusingheatmode.SeeSection6.2forforinformation.
5.1 – Timer Mode
With this mode, the unit will automatically turn on or o and regulate temperature according to
the selected times.
• Turningtimermodeonwhentheunitisomeanssettingthetimetheunitwillturnon.
• Turningtimermodeonwhentheunitisonmeanssettingthetimetheunitwillrunbeforeitshutso.
• Aftersettingthetimer,theACunitwillentertimermode.Whiletheunitisintimermode,itwilloperateaccordingtothe
 selectedtimerduration.Pressingthetimerbuttonagainwillturntimermodeoandcancelanydurationsetting.
To Set a Turn On Time
1. When the unit and remote are o, press the timer button on the control panel or remote.
2. Use the up and down buttons (left/right on the remote) to select the time the AC unit will turn
on i.e. selecting “03” will prompt the unit to turn on in 3 hours’ time etc.
3. After the selection is complete, the display’s “Hr” light will turn on.
When a schedule is active, the unit will not turn on if the chosen temperature is higher than the indoor temperature.
To Set a Shutoff Time
1. When the unit and remote are on, press the timer button on the control panel or remote.
2. Use the up and down buttons (left/right on the remote) to select the time the AC unit will turn
o i.e. selecting “03” will prompt the unit to turn o in 3 hours’ time etc.
3. After the selection is complete, the display will show the current indoor temperature and the
“Hr” light will turn on.
5.2 – Fan Mode
With this mode, the unit will turn on and begin using the fan to promote air circulation.
1. Press the power button on the control panel or remote.
2. Press the mode button on the control panel or remote multiple times until the “Fan” light
turns on.
3. Use the fan button to cycle through speeds.