Operation Manual

10
6. General operation
6.1. Quick start
• Toscanslidesornegatives,slidetheswitchatthetopforthescanmodeandforselectingthe
 insertionslottotheleft“Filmscanner”position.
 Toscanphotos,slidebothswitchestotheright,totheposition“Photoscanner”.
• Placeslide,negativeorphototobescannedintherespectiveholder.
• Inserttheslideornegativeholderintotheinsertionslotontherightofthedeviceorplacethe
 photoholderintheslotonthetopofthedevice.
• Placethememorycardinthememorycardslot.
• Usingoneofthefollowingtwooptionsconnectthescannertopower:
 1.ConnecttheMultiScannertoacomputerusingtheUSBcable
 2.ConnectthedevicetothemainsusingtheUSBcableandtheUSBmainsadaptor.
• PushtheOn/O switchtoswitchontheMultiScanner.
• Forscanning,followtheinstructionsonscreen.Alwaysconrmselectionofthefunctionby
 pressingthe ENTERkey.
• YoucantransferthedatafromthememorycardtothecomputerviatheUSBconnection.For
 thispurpose,connecttheMultiScannertothecomputerusingtheenclosedUSBcable. 
 AfterselectingtheUSBmode,thescannerappearsasaremovablestoragedeviceunder 
 MyComputer.
Note:
• Iftheswitchforthescanmodeandtheswitchforselectingtheinsertionslotareinthe
 sameposition“Filmscanner”or“Photoscanner”,therespectiveLEDwilllightupnexttothe
 switch-onbutton.