User Manual

28
ENGLISH
Troubleshooting
If the Power Station fails to charge or power devices, check the following steps:
– Make sure the general Power ON/OFF button is ON. The buttons are green.
– Check the battery capacity. If it is less than 3%, charge the Power Station.
– Make sure that the power consumption does not exceed the rated power of the
connection.
– If an error code occurs, refer to the error code table on the next page.
– Do not operate the Power Station outside the permissible operating temperature.
(-10 – 40° C).
Error Codes
Input overvoltage protection: The symbol flashes for 5 seconds when an
input overvoltage is detected.
Output overload protection: The symbol flashes for 5 seconds when an AC
output overload is detected.
Low power alarm: The icon flashes when the Power Station battery capaci-
ty is less than 3%.
Low temperature alarm: The low temperature symbol is displayed when an
attempt is made to use the Power Station outside the permissible opera-
ting temperature.
High temperature alarm: This high temperature symbol is displayed when
an attempt is made to use the Power Station outside the permissible
operating temperature.