Owners manual

[phone] • www.rollnlock.com
page 7
S TEP 5: O RIENTING THE T RACKS TO THE T AILGATE
A. Move
to the
front of
the bed,
lift up
slightly
on the
Housing
and shift
each side
back
toward the tailgate (Photo 20) so that the Track End Caps contact the inside
surface of the tailgate. Make sure the Track End Cap metal blocks contact
the Tailgate Extrusion End Caps (Diagram 21).
Note: If the Tracks are
not positioned as shown, the Latch Mechanism will not function
correctly.
B. With the Tracks in the correct position, you may now tighten the Track Clamps
to the threaded blocks. Begin with the back clamps and be sure the Tracks
remain level when tightening.
Note: Do not use a power or pneumatic
screw gun.
S TEP 6: I NSTALL C ARGO S HIELD & D RAIN T UBES
A. Trim the track gasket 1" from the end of the Track (Photo 22) .
B. Rotate
the Lock
Lever
to the
7 o’clock
(closed)
position
(Photo
23), then
remove
the plastic
wing nut and detach the Pull-Strap from the
threaded Stud (Photo 24). Pull the Cover
closed and latch it to the tailgate.
Note: Do
not allow the Cover to retract while the
Housing Lid is open.
Diagram 21Photo 20
Photo 23Photo 22
Photo 24
Track
Tailgate
Extrusion