Owners manual

[phone] • www.rollnlock.com
page 5
S TEP 3: I NSTALL THE T RACKS ON D ECK R AIL
E QUIPPED B EDS ( CONTINUED )
Note: The threaded hole is off-centered and the block must be
inserted with the hole closest to the bottom
(Photo 9) .
Note: Tracks for 2007 Tundra truck beds are shipped with the clamp
setups for both applications with and without “Deck Rail Systems”.
Before proceeding with an application with deck rails, you must first
remove the Clamps shown
(Photo 10) .
C. Lower
the
tailgate
and
place the
driver’s
side
Track
onto the
bedrail
(Photo
11), and
key it
onto
Housing
Stem
(Diagram
12), being
sure
that the
Handle is
properly
engaged into the Track.
D. Using 1/4-20 x 1-1/4" countersunk screws,
loosely secure the Tracks to the threaded
blocks (Photo 13).
Do not tighten.
E. Use #10-24 x 1/2" truss head screw and
Cargo Nuts to secure the Tracks to the
Housing Stems (Photo 14). Tighten these
connections securely.
F. With the driver’s side Track in place, repeat
sub-steps B-E for the passenger’s side
Track.
Photo 14
Truss Head Screws
Cargo Nut
Photo 10
Photo 13
Photo 11
Photo 9
Diagram 12
Track
Housing
Stem