Owners manual

[phone] • www.rollnlock.com
page 3
Installation with Deck Rail System
S TEP 1: B EDLINER M ODIFICATION
Note: If the truck is equipped with a plastic drop-in bedliner, some
alterations will be required. If no bedliner is present, proceed to Step 2.
A. To remove the bedliner for alteration, you
must fi rst remove only the bulkhead deck
rail (Photo 1).
B. The dotted lines in (Diagram 2) depict the
area which must be cut out. Using a jig saw
with a medium tooth blade, remove the
bulkhead portion of the liner as indicated.
Be sure to trim the bedliner's plastic
tailgate panel as shown.
C. Place the liner
back into the
truck bed. The
side panels
of the liner
will key under
the deck rails
(Photo 3).
Note: Do not
replace the
bulkhead
deck rail.
Photo 1
Photo 3
(2)1/2" DIAMETER HOLES
located as required
TAILGATE PANEL
BEDLINER
CUT
1"
6
1/2
” (Shortbed)
7
1/2
” (Longbed)
5”
Diagram 2
Typical
under-the-rail
bed liner