Owners manual

[phone] • www.rollnlock.com
page 14
S TEP 5: O RIENTING THE T RACKS TO THE T AILGATE
A. With the Tracks already moved back so
that the Track End Caps contact the inside
surface of the tailgate. Make sure the Track
End Cap metal blocks contact the Tailgate
Extrusion End Caps (Diagram 49).
Note:
If the Tracks are not positioned as
shown, the Latch Mechanism will not
function correctly.
B. With the Tracks in the correct position, you
may now tighten the Track Clamps to the
L-brackets, beginning with the back
clamps. However, if there is a space
between the L-bracket and Track Clamp,
a shim or shims will be required to prevent
the Tracks from pitching downward when
tightened (Photo 50). For proper function
and water resistance, the Tracks must be
set squarely to the bed.
Note: Do not use a power or
pneumatic screw gun to tighten the
Clamps.
S TEP 6: I NSTALL C ARGO S HIELD & D RAIN T UBES
A. Trim the
track
gasket 1"
from the
end of
the Track
(Photo
51).
B. Rotate
the Lock
Lever to the 7 o’clock (closed) position
(Photo 52), then remove the plastic wing nut
and detach the Pull-Strap from the threaded
Stud (Photo 53). Pull the Cover closed and
latch it to the tailgate.
Note: Do not allow
the Cover to retract without the Lid in
place.
Photo 50
Diagram 49
Photo 52
Photo 53
Photo 51
Track
Tailgate
Extrusion