Owners manual

[phone] • www.rollnlock.com
page 13
S TEP 4: I NSTALL THE T AILGATE E XTRUSION
A. Lower the tailgate and insert fi ve (5) plastic
shims beneath the inside fl ange of the
tailgate cap in the locations shown (Photo
44; Diagram 45).
B. Measure, locate and mark the center of the
tailgate and Tailgate Extrusion (Photo 46)
.
C. Center the Tailgate Extrusion on the tailgate
by aligning your marks. Being sure to hold
the Tailgate
Extrusion
square
to the
tailgate,
use a
#8 x 3/4"
self-
tapping
screw and
power
screw gun
to secure
the hole nearest the center, making sure the
screw passes through the shim described in
Step 4 (A) above (Photo 47).
D. Secure each end hole, again being sure to
hold the Tailgate Extrusion tight and square
to the tailgate (Photo 48), and then secure
the two remaining holes.
Diagram 45
Photo 46
Photo 44
Photo 48Photo 47
NOTE:
PLACE
PLASTIC
SHIM UNDER
TAILGATE
TRIM CAP AS
SHOWN