Owners manual

[phone] • www.rollnlock.com
page 12
S TEP 3: I NSTALL THE T RACKS ( CONTINUED )
C. Use #10-24 x 1/2" truss head screw and Cargo Nuts to secure the Track to the
Housing Stem (Photo 39). Tighten these connections securely.
D. With the
driver’s
side Track
in place,
repeat
sub-steps
B and C
for the
passen-
ger’s
side Track.
E. With the
Tracks
secured
to the
Housing,
close the
tailgate,
being
especially
careful not
to strike the ends of the Tracks. Now move
to the front of the bed, lift up slightly on the
Housing and shift each side back (Photo
40), until the Track End Caps contact the
inside surface of the tailgate.
F. The Track Clamps should now be perfectly
aligned with the L-brackets (Photo 41).
If the Track Clamps do not align with the
L-brackets, lift the Tracks just enough to
access the L-bracket screws, and reset the
L-brackets to align with the Track Clamps
(Photo 42).
Note: The Tracks can only
go in one place (caps against tailgate),
so the L-brackets must be moved to
match the Track Clamps, not vice-
versa.
G. Use 5/16-18 x 1" socket head bolts and lock
washers to secure the Track Clamps to the
L-brackets (Photo 43).
Do not tighten yet.
Photo 40
Photo 43
Photo 42
Photo 41
Photo 39
Truss Head Screws
Cargo Nut
Diagram 38
Track
Housing
Stem