Owners manual

[phone] • www.rollnlock.com
page 11
S TEP 3: I NSTALL THE T RACKS
A. Use 6mm
screws
provided
in the
hardware
package
to secure
the L-
brackets
to the
threaded
holes at the top of the bed walls (Photo 35).
Tighten in place with the screw at the center
of the oblong slot.
Note: Tracks for 2007 Tundra truck
beds are shipped with clamp setups
for both applications with and
without “Deck Rail Systems”. Before
proceeding with an application without
deck rails, you must first remove the
Clamps shown
(Photo 36).
B. Lower the tailgate and place the driver’s side Track onto the bedrail (Photo
37), and key it onto Housing Stem (Diagram 38), being sure that the Handle is
properly engaged into the Track.
S TEP 2: I NSTALL THE H OUSING ( CONTINUED )
B. Lift the Lid on the Housing and lean it against the cab (Photo 33). Place a rag between
the Lid
and cab
to prevent
scratches.
C. Making
sure to
leave
the Pull-
Strap
connect-
ed
to the threaded shipping Stud, rotate the Lock
Lever to the 10 o’clock position (Photo 34).
Photo 34
Photo 33
Photo 36Photo 35
Photo 37