Owners manual

[phone] • www.rollnlock.com
page 7
STeP 7: INsTall Cargo shIeld & draIN TuBes
A. Trim the track gasket 1" from the end of the
Track (Diagram 21).
B. Rotate the Lock to the 7 o'clock (closed)
position (Diagram 22) then remove the plastic
wing nut and detach the Pull Strap from the
threaded Stud (Diagram 23). Pull the Cover
closed and latch it to the tailgate. Note: Do
not allow the Cover to retract while the
Housing Lid is open.
C. Before lowering
the Housing
Lid, turn the Lid
Pin Knobs 1/4
turn clockwise,
which will cause
the pins to pop
in if they are not
already. Lower
the Housing Lid,
being sure that
the Lid Pins snap into the receptors located
on the Tracks.
D. To open the Cover, pull back slightly on the
Handle to relieve spring tension from the
Latch Mechanisms and turn the Lock Lever
clockwise to the 10 o'clock (unlatched)
position. While holding the pull strap, allow
the Cover to retract back into the housing
with just enough force to reset the Lock Lever.
E. Use the 14-20 x 1/2" truss head screws and
rubber washers supplied, to secure the Cargo
Shield (Diagram 24). Note: The rubber
washers go on the inside of the
Cargo Shield.
F. Attach one end of the Drain Tube to the Drain Fitting on the bottom of the
Housing, insert the other end of the Tube through the existing hole, on the side
of the truck next to the tie down hook (Diagram 25), Repeat for the other side.
If a bed liner is present, a 1/2" hole may need to be drilled through the bed liner
to access the existing hole in the truck.
G. Always make sure the Pull-Strap is securely clipped to a fixed point in
the bed.
Diagram 21
Diagram 23
Diagram 25
Diagram 22
drain tube
Diagram 24
Truss Head Screws
Cargo Bumper
Rubber Washers