Owners manual

[phone] • www.rollnlock.com
page 5
STeP 4: INsTall The TraCks
A. Making sure
to leave the
Pull Strap
connected to
the threaded
shipping stud,
rotate the Lock
Lever to the 10
o’clock position
(Diagram 9).
B. Unwrap the Tracks and locate the supplied Bed
Clamps that are taped together, along with the
bolts and washers. Unwrap the Clamps and set
them in the bed of the truck. Carefully place the
Tracks on the bedrails (Diagram 10) and key
them onto the Housing Stems (Diagram 11),
being sure that the Handle is properly engaged
into the Tracks.
C. Attach the back
Clamps very
loosely to the
Tracks to be
sure that the
Tracks do not
fall off of the
bed rail while
proceeding
(Diagram 12) .
Note: The
Clamps are
different and
are marked to note the difference. The
Clamps marked "2" are used at the front
and back locations, the Clamp marked
with an "X" is used at the center location
(Diagram 13).
D. Use the #10-24 x 1/2" truss head screws and
Cargo Nuts supplied to secure the Tracks to the
Housing Stems (Diagram 14). Tighten these
connections securely.
E. Attach the remaining Clamps very loosely.
Do not tighten yet.
Diagram 9
Diagram 12
Diagram 10
Diagram 13
Diagram 11
Diagram 14
"2"
"X"
"2"