Owners manual

[phone] • www.rollnlock.com
page 3
STeP 1: BedlINer modIfICaTIoN
Note: If the truck is
equipped with a plastic
drop-in bedliner, some
alteration will be necessary.
If no bedliner is present,
proceed to Step 2.
The dotted lines in
(Diagram 1) depict the
more common under-the-
rail liner modications.
A. Remove the bedliner
from the truck and
using a jig saw with a
medium tooth blade,
remove the bulkhead
portion of the liner as
indicated. Replace the
bedliner in the truck.
B. The top of the tailgate protector panel needs to be 1 3/4" from the top of the
tailgate. With the panel still in place measure down from the top of the tailgate
1 3/4" and mark a straight cut line across the top of the panel (Diagram 2) .
If the existing panel is below the 1 3/4" line, proceed to Step 2. If the plastic
protector panel is above the line, remove the panel and carefully make a
straight cut to remove that portion of the panel (Diagram 3). Replace the
plastic protector panel.
Diagram 3
Cut line
Diagram 1
Recommendation: Drill
(5) 3/8" holes along the
front corner of bedliner
for drainage.
(2) 1/2" Diameter
holes for drain tubes,
located as required.
REFER TO STEP 7-F.
5"
Diagram 2
Top of tailgate
Tailgate protector panel
1
3/4
"