Owners manual

[phone] • www.rollnlock.com
page 5
S TEP 3: I NSTALL THE T RACKS ( CONTINUED )
D. Attach
the back
Clamps very
loosely to
the Tracks
to be sure
that the
Tracks do
not fall off
of the bed
rail while
proceeding (Photo 10).
E. Use #10-24 x ½" truss head screws and
Cargo Nuts to secure the Tracks to the
Housing Stems (Photo 11). Tighten these
connections securely.
F. Attach the remaining Clamps very loosely.
Do not tighten yet.
Photo 10
S TEP 4: I NSTALL THE T AILGATE E XTRUSION
A. Lower the tailgate and use a tape measure
to locate and mark the center of the tailgate
(Photo 12).
B. Use a tape measure to locate and mark the
center of the Tailgate Extrusion (Photo 12).
C. While holding the Tailgate Extrusion square
and centered on the tailgate, use a #8 x ¾"
self-tapping screw and power screw gun to
secure the hole nearest center (Photo 13).
Next, move to each end,
press the Tail gate
Extrusion to the top of the tailgate in order
to make it conform to the contour of the
tailgate, and secure it in place.
D. Install the remaining self-tapping screws,
making sure to provide even spacing between
them.
E. With the Tailgate Extrusion secured, carefully
close the tailgate, being cautious not to strike
the ends of the Tracks.
Photo 12
Photo 13
Photo 11
Truss Head Screws
Cargo Nut
Track
Housing
Stem
Diagram 9
Track
Housing
Stem