Owners manual

[phone] • www.rollnlock.com
page 4
S TEP 2: I NSTALL THE H OUSING
A. If desired, install the Stake-Pocket Hole
Covers where necessary (Photo 3).
B. Place the Housing Assembly onto the bedrails
(Photo 4). This is best accomplished with two
people. Center it between the bedrails and
leave about ½" of space between the bulkhead
and the back of the Housing.
Do not fasten the Housing in place.
C. Lift the
Lid on the
Housing
and lean
it against
the cab.
(Photo 5)
Place a rag
between the
Lid and cab
to prevent
scratches.
Photo 3
Photo 5Photo 4
S TEP 3: I NSTALL THE T RACKS
A. Making
sure to
leave the
Pull Strap
connected
to the
threaded
shipping
stud,
rotate
the Lock
Lever to the
10 o’clock position (Photo 6).
B. Remove the “L”-shaped sections of Clamps
that are taped to the bottoms of the Track
Clamps
(Photo 7). Because these are
location-specifi c, be sure to lay them
in the bed in the same order as you
remove them from the Tracks.
C. Carefully place the Tracks on the bedrails
(Photo 8) and key them onto the Housing Stems
(Diagram 9), being sure that the Handle is properly engaged into the Tracks.
Photo 7Photo 6
Photo 8