Owners manual

[phone] • www.rollnlock.com
Page 7
Step 7: Install Cargo Shield & Drain Tubes
Place the gasket on the outside of the reel support
(Diagram 19).
Rotate the Lock Lever to the 7 o’clock (closed)
position (Diagram 20), then remove the plastic wing
nut and detach the Pull Strap from the threaded
Stud (Diagram 21). Pull the Cover closed and latch
it to the tailgate.
Note: Do not allow the Cover to retract while the
Housing Lid is open.
Before lowering
the Housing Lid,
turn the Lid Pin
Knobs 1/4 turn
clockwise, which
will cause the
pins to pop in
if they are not
already. Lower
the Housing Lid,
A.
B.
C.
D.
E.
F.
G.
Diagram 19
Diagram 20 Diagram 21
being sure that the Lid Pins snap into the receptors
located on the Tracks.
To open the Cover pull back slightly on the Handle
to relieve spring tension from the Latch Mechanisms
and turn the Lock Lever clockwise to the 10 o’clock
(unlatched) position, while holding the pull strap
allow the Cover to retract back into the housing with
just enough force to reset the Lock Lever.
Use the 14-20 x 1/2” truss head screws and rubber
washers supplied to secure the Cargo Shield
(Diagram 22).
Note: The rubber washers go on the inside of the
Cargo Shield.
Use the 1/2” bit to drill 2 holes for Drain Tubes. Note
that this process is easier if a 1/4” pilot hole is drilled
rst. Align the holes with the Drain Fittings that
protrude from the bottom of the Housing Assembly
(Diagram 23). If provided, locate the Drain Tubes in
factory drain holes or bulkhead plugs.
Always make sure the Pull-Strap is securely clipped to a xed point in the bed.
Cargo
Shield
Drain Tube
Truss Head Screws
Rubber Washers
Gasket
Diagram 22
Diagram 23