Owners manual

Page 6

Step 6:Orienting the Tracks to the Tailgate

If the Track pitches upward, loosen the

Clamp, rotate the Track level and install

the optional Angularity Adjustment Screw

as shown (Diagram 18). Tighten the screw

until it biases against the bedrail down-

ange as shown

With the Tracks in the correct position, you

may now tighten the Clamps in the order

shown (Diagram 17) taking care to make

sure the Tracks remain level. Do not use

a power or pneumatic screw gun. Over

tightening Track Clamps can cause an

indentation in the bedrails

Move to the front

of the bed, lift up

slightly on the

Housing and shift

each side back

toward the tailgate

(Diagram 15) so

that the Track

End-Caps contact

TIGHTENING SEQUENCE

➛

TIGHTEN 2nd

TIGHTEN 3rd

TIGHTEN 4th

TIGHTEN 1st

TAILGATE

90 APPROXIMATELY

ANGULARITY ADJUSTMENT SCREW

(FOR ADJUSTMENT ONLY)

Diagram 15

Diagram 16

Diagram 17

Diagram 18

the inside surface of the tailgate. Make sure the Track End Cap Metal Blocks contact the

Tailgate Extrusion End Caps (Diagram 16). Note that if the Tracks are not positioned

as shown, the Latch Mechanism will not function correctly.