Owners manual

[phone] • www.rollnlock.com
Page 5
Step 4: Modication of the Tailgate
Extrusion with No Integral Step
STOP:
IF THE TAILGATE IS EQUIPPED WITH AN INTEGRAL TAILGATE STEP PROCEED TO
STEP 5: INSTALL THE TAILGATE EXTRUSION
An alternative center section (“D”) for the tailgate
extrusion has been supplied for trucks with no
integral step. Using the allen wrench provided
loosen the set screws and remove the joining block
(Diagram 11). Repeat for the other side. Discard
the shims and the center section (“C”) tailgate
piece.
Place the shim provided over the set screws and
insert the joining block back 1/2 way into tailgate
piece (“A”) (Diagram 12) tighten set screw.
Make sure the locking pin is on the opposite end
of the joining block. Repeat for tailgate piece
(“B”).
Slide the supplied alternative center tailgate
piece (“D”) onto tailgate piece “A” and “B”.
Making sure there is a snug t; tighten the 4 set
screws (Diagram 13).
A.
B.
C.
Diagram 11
Diagram 12
Diagram 13
joining block
locking pin
set screw
allen wrench
shim (discard)
(discard)
A
A
A
D
B
C
Step 5: Install the Tailgate Extrusion
Lower the tailgate and use a tape measure to
center the Tailgate Extrusion onto the tailgate.
With the Tailgate Extrusion secured, carefully close the tailgate, being cautious not to
strike the ends of the Tracks.
A.
B.
C.
While holding the Tailgate Extrusion square and
centered on the tailgate, use the self-taping screws
provided and a power screw gun secure the
Tailgate Extrusion to the tailgate (Diagram 14).
Note: If tailgate has the integral tailgate step
use 2 fasteners on each end to secure the
Tailgate Extrusion. If tailgate has no integral
step an additional fastener in the center of the
Tailgate Extrusion can be used.
X
X
X=X
Diagram 14