Owners manual

ManualsBrandsRoll-N-Lock ManualsAutomotiveBT109A Roll-N-Lock A-Series Truck Bed Cover

Page 6

Step 6:Install the Tailgate Extrusion

Step 7:Orienting the Tracks to the Tailgate

Lower the tailgate and use a tape measure to

center the Tailgate Extrusion onto the tailgate.

Replace the metal tailgate access panel (if

applicable) and the plastic tailgate protector panel,

secure to the tailgate. Note: A portion of the

metal tailgate panel will overlap the Tailgate

Extrusion (Diagram 15).

If the Track pitches upward, loosen the Clamp, rotate the

Track level and install the optional Angularity Adjustment

Screw as shown (Diagram 19). Tighten the screw until it

biases against the bedrail down-ange as shown

With the Tracks in the

correct position, you may

now tighten the Clamps in

the order shown (Diagram

18) taking care to make

sure the Tracks remain

level. Do not use a power

With the Tailgate Extrusion secured, carefully close the tailgate, being cautious not to

strike the ends of the Tracks.

Move to the front of the bed, lift up slightly on the Housing

and shift each side back toward the tailgate (Diagram 16)

so that the Track End-Caps contact the inside surface of

the tailgate. Make sure the Track End Cap Metal Blocks

contact the Tailgate Extrusion End Caps (Diagram 17).

Note that if the Tracks are not positioned as shown,

the Latch Mechanism will not function correctly.

While holding the Tailgate Extrusion square and

centered on the tailgate, use the self-taping screws

provided and a power screw gun secure the

Tailgate Extrusion to the tailgate (Diagram 14).

Note: If tailgate has the integral tailgate step

use 2 fasteners on each end to secure the

Tailgate Extrusion. If tailgate has no integral

step an additional fastener in the center of the

Tailgate Extrusion can be used.

X=X

TIGHTENING SEQUENCE

➛

TIGHTEN 2nd

TIGHTEN 3rd

TIGHTEN 4th

TIGHTEN 1st

TAILGATE

90 APPROXIMATELY

ANGULARITY ADJUSTMENT SCREW

(FOR ADJUSTMENT ONLY)

Diagram 14

Diagram 15

Diagram 16

Diagram 17

Diagram 18

Diagram 19

or pneumatic screw gun. Over tightening Track

Clamps can cause an indentation in the bedrails