Installation Instructions

3. Sun Sensor Installation Check

Make sure all screws are securely fastened into the bracket and

Sun Sensor.

Note: Device is designed for interior installations only.

4. Sun Sensor Testing

Correct - Perfect Placement

Correct - Sensor location clear of obstructing shadows

Incorrect - Sensor obstruction by shadows

Faces outside

SUN SENSOR

BACK

Roll-A-Shade Eclipse

FCC ID: 2AUXUECLIPSE-S1

Contains FCC ID: QOQMGM12P3

This device complies with part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Faces into room

FRONT