Product Manual

Spacers
Spacers for 12”(30.48cm) models:
Spacers hold the ramps parallel
to each other to assure that your
12” (30.48cm) Roll-A-Ramps
stay at the correct width. We can
provide you with spacers of various
sizes to accommodate any axle
width. Spacers are attached by
simply snapping onto the ramp as
illustrated below.
Support Stand Installation
Instructions:
For ramps over 11 , support stands are
recommended.
1. Set up ramp to desired location.
2. Place support stands under ramp
at midway point (or every 6-8 )
and adjust height so that support
stands are same height as ramp.
3. Place ramp bracket onto the
railing on the bottom of the ramp
spanning between 2 links.
4. Tighten bolts for secure
placement and adjust height
with adjustment pins and ne
adjustment threads. en your
new ramp system is ready to use.
Spacers
Support Stand