User guide

030-300564 Rev A 86 August 2009
User Guide ProLine G90
(
Models 6100
,
6110
)
Status Click this drop-down menu to enable or disable your VC (Virtual Connection).
“Enable” must be displayed to edit VC settings.
VPI Displays the VPI (Virtual Path Indicator) value for a particular VC, which is defined
by your ISP.
VCI Displays the VCI (Virtual Channel Indicator) value for a particular VC, which is
defined by your ISP.
Protocol
Note: The configuration
specified by your ISP will
determine which
Protocols are available to
you.
Displays the Protocol for each VC, which is specified by your ISP.
• PPPoA: Point to Point Protocol over ATM (Asynchronous Transfer Mode).
• PPPoE: Point to Point Protocol over Ethernet.
• Bridge: Bridge Protocol.
Edit Click Edit button to edit the VC using the VC 1 Configuration window. Refer to
section 13.4.3.1, “VC 1 Configuration.”
13.4.3.1 VC 1 Configuration
The following screen will appear if you click the Edit button from the VCs screen (Advanced > WAN > VCs >
Edit). This screen allows you to edit your VCs. If you change the settings in this screen, click set VC and then OK.
If you click Cancel, the screen will return to its previous settings.
VC 1 Configuration
VPI
Displays the VPI (Virtual Path Indicator) value for a particular VC, which is defined
by your ISP.
VCI
Displays the VCI (Virtual Channel Indicator) value for a particular VC, which is
defined by your ISP.