User guide
030-300564 Rev A 83 August 2009
User Guide ProLine G90
(
Models 6100
,
6110
)
Public LAN DHCP Server Enable Click this check box to enable the Public LAN DHCP Server feature.
DHCP is an Internet standard that allows the modem to automatically
assign IP addresses to devices connected on the LAN. It is recommended
that you enable this for the public LAN. By default, Public LAN DHCP
Server Enable is enabled (checked).
Public LAN Enable Click this check box to enable the Public LAN feature. This setting
enables the Public interface, which allows for a global subnet to exist
behind your modem. Westell recommends that you leave this feature
enabled. By default, Public LAN Enable is enabled (checked).
Public LAN IP Address Displays your modem’s IP address.
Public LAN Subnet Mask Displays the Public LAN Subnet Mask that is used to determine if an IP
address belongs to your local network.
DHCP Start Address (if DHCP is
enabled for Public LAN)
Displays the first IP address that the DHCP server will provide to assign
IP addresses to local devices.
DHCP End Address (if DHCP is
enabled for Public LAN)
Displays the last IP address that the DHCP server will provide for
automatic configuration of local devices.
DHCP Lease Time (if DHCP is
enabled for Public LAN)
Displays the DHCP lease time in days/hours/minutes/seconds. This is the
amount of time the provided addresses will be valid, after which the
DHCP client will usually re-submit a request. DHCP Lease Time must be
greater than 10 seconds (seconds must be between 0 and 59; minutes must
be between 0 and 59; and hours must be between 0 and 23). By default,
DHCP Lease Time is set to 01:00:00:00.