User guide

030-300564 Rev A 48 August 2009
User Guide ProLine G90
(
Models 6100
,
6110
)
Service Name Displays the name of the selected service.
Protocol Displays the IP Protocol type.
• TCP: Transmission Control Protocol.
• UDP: User Datagram Protocol.
• BOTH: Both Transmission Control Protocol and User Datagram Protocol.
Start Point Displays the starting Port number for Incoming/Outgoing Packets.
End Point Displays the ending Port number for Incoming/Outgoing Packets.
LAN Port Displays the port number to map the Incoming WAN Packets to.
Port Displays the port that needs to be checked.
• Dst: Rule will be created for destination port.
• Src: Rule will be created for source port.
• BOTH: Rule will be created for both the destination and source ports.
Packet Direction Select these options to set the direction for the rules in the predefined service. These
options will only be shown for pre-defined services.
• Inbound Only: All the rules of the service will be applicable for the incoming
traffic from the outside network.
• Outbound Only:
All the rules of the service will be applicable for the outgoing
traffic from the local network.
• Both: A
ll the rules of the service will be applicable for the incoming as well as
outgoing traffic to and from the modem.
Select LAN Device
OR
Enter an IP address
Click this drop-down menu to select the IP Address of the LAN computer for this
service; or, you can select the “name” of the computer from the drop-down menu. If
you enable the Dynamic Application check box, then the IP Address field will be
disabled and contain the IP address of 0.0.0.0.
Dynamic Application Click this check box to enable Dynamic Application, which will only allow outgoing
connections from any local PC. If the Dynamic Application check box is not
checked, then the service will be applied as a host service.