User guide

030-300564 Rev A 12 August 2009
User Guide ProLine G90
(
Models 6100
,
6110
)
6. INSTALLING THE USB DRIVERS
This section explains how to install the USB drivers for your modem. If you are using only an Ethernet connection,
USB driver installation is not necessary. The Microsoft Plug and Play (PnP) auto-detect feature recognizes when
new hardware has been installed. After you connect the modem to the PC, the modem will be detected
automatically.
IMPORTANT: Make sure that the CD-ROM provided with your kit is inserted into the PC’s CD-ROM drive before
connecting the USB jack, as explained in section 5.1.2, “Connecting USB Devices to Your Modem.”
Determine which operating system is installed on your PC, and then follow the USB driver instructions that match
your operating system. The following table provides a reference to the USB driver installation instructions. After
you have completed the USB driver installation, return to section 5.1.2, “Connecting USB Devices to Your
Modem,” to complete the USB hardware installation instructions.
Your Operating System Refer to this section for USB driver instructions
Windows 2000 6.1. Installing the USB Driver for Windows 2000
Windows XP 6.2. Installing the USB Driver for Windows XP
Windows Vista™ 6.3. Installing the USB Driver for Windows Vista™
6.1 Installing the USB Driver for Windows 2000
To install the USB driver for Windows 2000, please follow these steps:
IMPORTANT: Confirm that the CD-ROM provided with the modem kit is inserted into the PC’s CD-ROM drive
before beginning this installation.
1. Windows 2000: After you connect the modem to your PC, the Found New Hardware window will appear
(Figure 1). After a brief delay, the Found New Hardware Wizard will appear (Figure 2). Click Next.
Figure 1. Windows 2000