User guide

030-300564 Rev A 100 August 2009
User Guide ProLine G90
(
Models 6100
,
6110
)
After a brief delay, the Home screen will appear. Confirm that you have a DSL sync and that your PPP session
displays UP. (If necessary, click connect in the Home > Connection Overview screen to establish a PPP session).
Select Advanced > Single Static IP to confirm that Single Static IP has been enabled, as shown in the following
screen.
IMPORTANT: After you enable Single Static IP, reboot your computer to allow the changes to take effect.
NOTE: If you chose to enable User Configured PC, wait for the modem to reset, and then manually type the WAN
IP, Gateway, and Subnet mask addresses you obtained from your ISP into a PC.
To disable Single Static IP, select a device that will share your Single Static IP from the options listed in the
window, click Disable and then OK. Your modem will be reset, and the new configuration will take effect.
After a brief delay, the Home screen will appear. Confirm that you have a DSL sync and that your PPP session
displays UP. (If necessary, click connect in the Home > Connection Overview screen to establish a PPP session).
Select Advanced > Single Static IP to confirm that Single Static IP has been disabled.