Owner`s manual

Using VR-09 Editor
14
Editing a VR-09 Synth Tone
Here’s how to read the settings of a Synth Tone from the VR-09 into
VR-09 Editor, and edit those settings.
1. Tap the [READ] button.
The Synth Tone parameters will be sent from the VR-09 to VR-09 Editor. The
current Synth Tone parameter settings of the VR-09 will appear in VR-09 Editor.
MEMO
• If you’ve operated the VR-09 itself, tap the [READ] button. The current
state of the VR-09 will be read into VR-09 Editor.
• When used in combination with an Organ Tone, you can tap the [ORGAN]
button to switch the display to the Organ Tone.
2. Edit the parameters.
The edited parameters will be sent to the VR-09. Parameter settings are
reected on the VR-09 in real time.
Knobs and sliders
Drag a knob or slider up/down to
change its value.
MEMO
• Make ne adjustments to the value
by dragging to left or right.
• You can reset the value to its initial
state by rapidly tapping three times.
Buttons and switches
Tap a button or switch to change its
setting.
PCM number
If tapped when PCM has been selected
for WAVE, the WAVE NUMBER popup will
appear.
[READ] button
MEMO
Parameter editing supports the
“multi-touch” capability of the iPad.
You can edit multiple parameters
simultaneously.
Roland website “Support Information”
http://www.roland.com/support/