User manual

Introduction
8
7. [MASTER EFFECT] knob
Changes the master effect.
8. MASTER EFFECT [ON/OFF] button
Turns the master effect on/off.
9. PAD EDIT [1] [2] knobs
Edits the various parameters.
10. [SELECT] button
Selects the target operations (the parameters to edit) for the PAD EDIT [1] [2] knobs.
[1] knob
[2] knob
Unlit
Off
Off
Top row lights
Layer Volume
Coarse Tune
Bottom row lights
Transient Attack
Transient Release
Both rows light
Assign
Assign
11. Display
Shows the kit name, wave name, contents of the settings and other information.
12. FUNCTION buttons 1–6
These buttons execute the functions shown in the display.
This guide refers to the buttons as the [F1]–[F6] buttons, in order from left to right.
13. [ALL SOUND OFF] button
Stops all sounds that are playing.
Note that you can’t use the [ALL SOUND OFF] button to mute the effect sounds to which the MASTER effect or KIT MFX are
applied (such as the delay reverberations, sounds that are looped with the looper effect and so on) or the click sound
(including the click track).
14. [PAD CHECK] button
While you’re pressing this button, the sound from the pads you strike is only output through the PHONES jack.
Hold down the [SHIFT] button and press the [PAD CHECK] button to call up the PREVIEW function.
15. [MENU] button
Recalls various functions like the settings for each kit, the overall settings for this unit and so on.
16. [SHIFT] button
By holding down this button and then pressing another button, the function of that button changes.
17. [VALUE] knob
Use this knob to switch between kits and change values.
18. Cursor buttons
Moves the cursor.
19. [EXIT] button
Returns to the previous screen. This also undoes an operation.
20. [ENTER] button
Used for confirming a value or executing an operation.
21. [KIT] button
Shows the top screen (kit screen).
22. [-] [+] buttons
Use these to switch between kits and change values.
You can use these buttons instead of the [VALUE] knob.