User manual

Effect List
190
Limiter
Compresses signals that exceed a specified volume level, preventing distortion from occurring.
Parameter
Value
Explanation
Release
0–127
Adjusts the time after the signal volume falls below the Threshold Level until compression is no
longer applied.
Threshold
(*1)
0–127
Adjusts the volume at which compression begins.
Ratio
1.5:1, 2:1, 4:1,
100:1
Compression ratio
Post Gain
0–+18 [dB]
Adjusts the output gain.
Low Gain
-15–+15 [dB]
Gain of the low range
High Gain
-15–+15 [dB]
Gain of the high range
Level
0–127
Output Level
*1: This parameter corresponds to MFX Ctrl. For details, refer to “Controlling the MFX with the PAD EDIT [1] [2] Knobs (MFX
Ctrl)(P.198)”.
*1: This parameter corresponds to MASTER EFFECT CTRL. For details, refer to “Controlling the MASTER EFFECT with the MASTER
EFFECT Knob (MASTER EFFECT CTRL)(P.199)”.
Gate
Cuts the reverb’s delay according to the volume of the sound sent into the effect. Use this when you want to create an artificial-
sounding decrease in the reverb’s decay.
Parameter
Value
Explanation
Threshold
(*1)
0–127
Volume level at which the gate begins to close
Mode
GATE, DUCK
Type of gate
GATE: The gate will close when the volume of the original sound decreases, cutting the
original sound.
DUCK (Duking): The gate will close when the volume of the original sound increases, cutting
the original sound.
Attack
0–127
Adjusts the time it takes for the gate to fully open after being triggered.
Hold
0–127
Adjusts the time it takes for the gate to start closing after the source sound falls beneath the
Threshold.
Release
0–127
Adjusts the time it takes the gate to fully close after the hold time.
Balance
D100:0W–
D0:100W
Volume balance between the direct sound (D) and the effect sound (W)
Level
0–127
Output Level
*1: This parameter corresponds to MFX Ctrl. For details, refer to “Controlling the MFX with the PAD EDIT [1] [2] Knobs (MFX
Ctrl)(P.198)”.