Specifications

3. Assembling and Installing
16
2. Secure the assembled take-up unit in place on the printer stand.

Check to make sure the screws on the printer stand are not loose.
Retighten if loose.

Place the take-up unit on the stand.

Determine where to secure the take-up unit in place.
Secure mounting xture A in place using bolts with washers.
The mounting location varies according to the printer.
Make sure the take-up unit is completely ush with the stand.
Place so that the control box and frame are pressed against the stand leg and mounting xture A is pressed against
the caster.
PRO II/PRO II V series, SP-540V
Place
pressed
against.
Stand
leg
Place
pressed
against.
Caster
Mounting xture A
Place
pressed
against.
Frame
Stand leg
Control box
Slot
Top
Bottom
Mounting xture A The
left and right sides
have no handedness.
Control box
Front side of the printer
Bolts with
washers
Hex wrench (small)