User`s manual

16
4-9 When Cutting Is Completed
(1) When cutting is finished, press down the sheet loading levers and remove the sheet. (See "Removing the Sheet" on
page 11.)
(2) If a blade was used, wipe the blade with a soft cloth to remove any pieces of the sheet that may be adhering to it. If
the pen was used then remove and recap the pen.
(3) Turn off the power.
If you do not intend to use the unit for an extended period of time, you should pull the plug for the power cord out of
the outlet.
* For routine cleaning, use a soft piece of cloth.
Performing a Self-test
The PNC-950 is equipped with a "self-test" function to conveniently allow you to check whether or not it is capable of
operating normally. If the PNC-950 is not performing correctly, follow the steps below to perform a self-test.
* A computer is not required in order to carry out the self-test.
(1) Refer to "4-3 Installing the Blade" on page 7 and install a blade holder (or pen) in the PNC-950's tool carriage.
(2) Set the pen force to the smallest possible value (the pen force slider should be at the furthest point to the left). If after
the first test you feel that the sheet was not cutout clean enough, you can try gradually increasing the pen force until
you have the optimum level.
(3) Hold down the key on the panel while you turn the power on.
(4) Load the sheet (or some paper), following the procedure
described in "4-4 Loading the Sheet" on page 8.
* If a pen and sheet have been loaded, press the
PEN MODE key to light up the PEN MODE LED.
(5) Press the SETUP key.
Demo cutting starts.
Operations is normal if
the figure shown at right is cut.
ON
OFF
POWER ON
+
SETUP