User`s manual

14
Performing a Self-test
The PNC-960/910 is equipped with a "self-test" function to conveniently allow you to check whether or not it is capable of operating
normally. If the PNC-960/910 is not performing correctly, follow the steps below to perform a self-test.
* A computer is not required in order to carry out the self-test.
1
11
2
22
3
33
4
44
ON
OFF
+
5
55
The SETUP LED
lights up
Refer to "3-3 Installing/Removing a Blade" and install a blade
holder (or pen) in the PNC-960/910's tool carriage.
Set the pen force to the smallest possible value (the pen force
slider should be at the furthest point to the left). If after the
cutting test you feel that the material was not cutout clean
enough, you can try gradually increasing the pen force until
you have the optimum level.
Hold down the
key on the panel while you turn the power
on.
Load the material (or some paper), following the procedure
described in "3-4 Loading/Removing the Material" .
* If a pen and material have been loaded, press the
PEN MODE key to light up the PEN MODE LED.
Press the SETUP key.
Demo cutting starts.
Operations is normal if
the figure shown at right is
cut.
3 Basic Operation
POWER ON