Owner`s manual

Connecting to the VK-8 (Turning the Power On)

Use a MIDI cable to connect the VK-8 and PK-25.

Make sure that the power of the VK-8 and PK-25 is turned off.

Use a MIDI cable to connect the VK-8’s MIDI PEDAL IN connector to the

PK-25’s MIDI OUT connector.

Connect the appropriate end of the AC adaptor to the DC IN jack. Then

connect the other end to a standard AC outlet.

Once the connections have been completed, turn on power to your various devices in the order

specified. By turning on devices in the wrong order, you risk causing malfunction and/or

damage to speakers and other devices.

Turn on the power of the PK-25, and make sure that the indicator on

the PK-25’s rear panel is lit.

As described in the VK-8 Owner’s Manual, turn on the power of the VK-8.

Make sure that the Sub-Keyboard Function is on (VK-8 Owner’s

Manual p. 58).

Play the pedal keyboard. If the pedal part is heard from the VK-8,

connections are complete.

Once you have made connections as described above, you can use the switches and pedals to

control the following functions.

•

Expression pedal: Control the volume of all parts of the Organ, and the Other Tones.

•

Foot switch L: Switch the rotary effect between slow/fast.

•

Foot switch R: Turn the rotary effect brake on/off.

•

Hold pedal: Hold (sustain) the sound of the Organ voice and Other Tones.

This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is

required before the unit will operate normally.

When the PK-25’s FOOT SW-L OUT/FOOT SW-R OUT/HOLD jack is connected to the

VK-8’s CONTROL PEDAL jack, you can assign a variety of functions to the foot switch.

Use a mono cable (phone-phone) to make connections.

→

Assigning a Function to the Control Pedal (VK-8 Owner’s Manual, p. 40)

When the PK-25’s EXPRESSION OUT jack is connected to the VK-8’s EXPRESSION

PEDAL jack, you can use the expression pedal to simultaneously control the volume of

all parts of the Organ

and the Other Tones. Use a stereo cable (phone-phone) to make

connections.

The MIDI transmission channel is fixed at channel 2.

Turn off the power of the PK-25 after turning off the power of VK-8.

NOTE

MEMO

NOTE

PK-25.e 8 ページ２００４年４月７日　水曜日　午後３時２０分