Owner`s manual

Connections

Connecting to the Expression Pedal

The PK-25 is shipped with the expression pedal detached. Before connecting the PK-25

to another device, please attach the expression pedal.

When attaching or detaching the expression pedal, be careful not to step on a knob bolt. When

removing the knob bolts, place them out of the reach of children. If a knob bolt is accidentally

swallowed, consult a doctor immediately.

Connect the expression pedal cable to the connector in the upper part

of the PK-25.

While being careful not to pinch the cable, place the expression pedal

on the PK-25.

Use the three supplied knob bolts to fasten the expression pedal,

making sure that the bolt holes are aligned.

The connector in the upper part of the PK-25 is only for connecting the supplied expression

pedal. Connecting this to any device other than the PK-25’s own expression pedal could result

in malfunction.

To prevent malfunction and/or damage to speakers or other devices, always turn down the

volume, and turn off the power on all devices before making any connections.

Connecting to the VK-88 (Turning the Power On)

Use the PK cable that is supplied with the VK-88 to connect the VK-88 and PK-25.

The supplied AC adaptor is not used. The PK-25 will be turned on/off by the power switch of the

VK-88, regardless of the position of the PK-25’s own power switch.

Make sure that the VK-88’s power is turned off.

Set the PEDAL KEYBOARD [SELECT] switch (located on the rear panel

of the VK-88) to the PK IN position.

Use the PK cable that is supplied with the VK-88 to connect the VK-

88’s PK IN connector to the PK-25’s PK OUT connector.

As explained on the VK-88 Owner’s Manual, turn on the power of the

VK-88.

Make sure that the indicator on the rear panel of the PK-25 is lit.

Play the pedal keyboard. If you hear the pedal part of the VK-88,

connections are complete.

This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is

required before the unit will operate normally.

You can select the part that will be sustained when you press the Hold pedal.

→

HOLD PEDAL ASSIGN (VK-88 Owner’s Manual, p. 80)

A variety of functions can be assigned to each foot switch (L/R).

→

PK FOOT L ASSIGN (VK-88 Owner’s Manual, p. 68)

→

PK FOOT R ASSIGN (VK-88 Owner’s Manual, p. 68)

NOTE

MEMO

NOTE

MEMO

PK-25.e 7 ページ２００４年４月７日　水曜日　午後３時２０分