Owner`s manual

11
MIDI Implementation
Model: PK-25 (MIDI Pedal Keyboard)
Date: Feb. 1, 2000
Version: 1.00
1. Transmitted Data
■ Channel Voice Messages
● Note off
Status
2nd byte 3rd byte
81H kkH 40H
kk = note number: 24H - 3CH (36 - 60)
● Note on
Status
2nd byte 3rd byte
91H kkH 78H
kk = note number: 24H - 3CH (36 - 60)
● Control Change
❍ Expression (Controller number 11)
Status
2nd byte 3rd byte
B1H 0BH vvH
vv = expression: 00H - 7FH (0 - 127)
* If the EXPRESSION OUT jack on the rear panel is in use, this unit doesn't send
Expression message via MIDI.
❍ General Purpose Controller 3 (Controller number 18)
Status
2nd byte 3rd byte
B1H 12H vvH
vv = control value: 00H, 7FH (0, 127)
* This message will be sent by operating a foot switch locating left side of the expression
pedal.
* If a FOOT SW-L OUT jack on the rear panel is in use, the unit doesn't send this message
via MIDI.
❍ General Purpose Controller 4 (Controller number 19)
Status
2nd byte 3rd byte
B1H 13H vvH
vv = control value: 00H, 7FH (0, 127)
* This message will be sent by operating a foot switch locating right side of the expression
pedal.
* If a FOOT SW-R OUT jack on the rear panel is in use, the unit doesn't send this message
via MIDI.
❍ Hold 1 (Controller number 64)
Status
2nd byte 3rd byte
B1H 40H vvH
vv = control value: 00H, 7FH (0, 127)
* If a HOLD OUT jack on the rear panel is in use, the unit doesn’t send Hold 1 message via
MIDI.
■ System Realtime Message
● Active sensing
Status
FEH
* This will be transmitted constantly at intervals of approximately 250 ms.
■ System Exclusive Messages
“Data Set 1 (DT1)” to control VK-8/7 is the only System Exclusive messages transmitted by
PK-25.
● Data Set1 DT1
Status
Data byte Status
F0H 41H, 10H, 00H, 08H, 12H, aaH, F7H
bbH, ccH, ddH, eeH, sum
Byte Remarks
F0H Exclusive status
41H ID number (Roland)
10H device ID
00H model ID
08H model ID (VK-8)
12H command ID (DT1)
aaH address MSB: The most significant byte of the address
bbH address
ccH address
ddH address LSB: The least significant byte of the address
eeH data: The actual data to be transmitted.
sum checksum
F7H EOX (End Of Exclusive)
* This unit sends the following messages to control ROTARY SOUND of the VK-8/7.
Refer to MIDI Implementation pages in the VK-8 Owner’s Manual.
F0 41 10 00 08 12 02 00 10 3D ... F7
(Rotary Speed: Transmit by FOOT SW-L)
F0 41 10 00 08 12 02 00 10 3E ... F7
(Rotary Rotation: Transmit by FOOT SW-R)
PK-25.e 11 ページ ２００４年４月７日 水曜日 午後３時２０分