User`s manual

Part 2 Operation Procedures

Step 1: Connect the computer and the 3D scanner with a cable

Use a cable to connect the computer and the 3D scanner.

For more information about cable connections, refer to the user's manual for the 3D scanner.

Step 2: Choose the communication port

Start up Dr.PICZA3 and make the choose the communication port that matches the terminal where the cable is

connected.

If the communication port is not set correctly, the 3D scanner will not operate. Be sure to make the setting after

setup.

1. From the [File] menu, click [Preferences...].

The [Preference] dialog box appears.

2. Choose the communication port.

3. Click [OK].

Step 3: Load the object to be scanned on the 3D scanner

Prepare the object to be scanned, and secure it on the 3D scanner.

For information on how to secure it in place, refer to the user's manual for the 3D scanner.