User`s manual

33
"Can't find 3D Engrave"
3D Engrave cannot be found your hard disk.
Install 3D Engrave.
"3D Editor is not in 'exe' format. File is missing or corrupted."
3D Editor cannot be started correctly.
If the same message keeps appearing, reinstall 3D Editor.
"MODELA Player is not in 'exe' format. File is missing or corrupted."
MDDELA Player cannot be started correctly.
If the same message keeps appearing, reinstall MODELA Player.
"3D Engrave is not in 'exe' format. File is missing or corrupted."
3D Engrave cannot be started correctly.
If the same message keeps appearing, reinstall 3D Engrave.
"File required by PICZA Driver not found. Please reinstall."
A file needed by PICZA Driver could not be found. Reinstall PICZA Driver.
"Cannot communicate with present scanner.. Try again?"
Test communication with the 3D scanner received no response.
Check the following.
- Is the power to the 3D scanner turned on?
-> Turn on the power.
- Is the cable disconnected or loose?
-> Connect the cable securely.
- Is the correct cable used to make the connection?
-> For information about cables, refer to the user's manual for the 3D scanner.
- Is the port selection correct?
-> Use the [File] - [Preference...] command to check the setting for the communication port.
"Library for the [Model Name] not found. Reinstall."
A library file for the 3D scanner (a file containing hardware information) cannot be found. Reinstall PICZA
Driver.
"[Port Name] not ready. Please verify that the port is valid or is not in use by another application."
The specified port is not in a usable state.
Make sure the specified port is not incorrect and is not being used by a printer driver. A port now in use cannot be
used concurrently.
"[File Name] was not found."
This message appears when the specified file in the [Recent File] list from the [File] menu cannot be found.
You can't open a file from the [Recent File] list when the location of the file you specify has been moved or the
specified file has been deleted.
Also, after this message appears, the name of the file that could not be found is removed from the [Recent File]
list.
"Data cannot be saved. Either there are only points and lines but no surface, or there is no surface whose
height is 0 (zero)."
There are no valid polygon surfaces, so the data could not be saved to another 3D program (file).
Data that contains only points and lines cannot be saved.
If there are no polygon surfaces within the specified range, reselect the range.